NETGEAR ProSafe XS748T User Manual

Configure Routing
165
ProSAFE 10-Gigabit Smart Managed Switch XS728T and XS748T User Manual
The updated configuration is sent to the switch. Configuration changes take effect
immediately.
The following table describes the IP configuration information displayed on the page.
View the IP Statistics
The statistics reported on this page are as specified in RFC 1213.
 To view statistics:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Change the Default IP Address of the
Switch on page 10.
The login window opens.
4. Enter the switch’s password in the Password field.
The default password is password.
The System Information page displays.
5. Select Routing> IP > Statistics.
Table 42. Global IP status information
Field Description
Default Time to Live The default value inserted into the Time-To-Live field of the IP header of
datagrams originated by the switch, if a TTL value is not supplied by the
transport layer protocol. The default value is 64.
Maximum Next Hops The maximum number of hops supported by the switch. This is a compile-time
constant. The default value is 1.

NETGEAR ProSafe XS748T Specifications

General

Brand	NETGEAR
Model	ProSafe XS748T
Category	Switch
Language	English