Configure System Information
52
ProSAFE 10-Gigabit Smart Managed Switch XS728T and XS748T User Manual
Change the Host Name or IP Address in an Entry of the Dynamic Host Mapping Table and
View All Entries
 To change the host name or IP address in an entry of the dynamic host mapping table
and view all entries:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Change the Default IP Address of the
Switch on page 10.
The login window opens.
4. Enter the switch’s password in the Password field.
The default password is password.
The System Information page displays.
5. Select System > Management > DNS > Host Configuration.
The DNS Host Configuration page display.
6. Select the check box for the entry to update.
7. Enter the new information in the appropriate field.
8. Click the Apply button.
The updated configuration is sent to the switch. Configuration changes take effect
immediately.
9. To clear all the dynamic host name entries from the list, click the Clear button.
The Dynamic Host Mapping table shows host name-to-IP address entries that the switch
learned. The following table describes the dynamic host fields.
Configure Green Ethernet Settings
Use this page to configure Green Ethernet features. Using the Green Ethernet Configuration
features allows for power consumption savings.
Table 11. Dynamic Host Mapping information
Field Description
Host The host name that you assign to the specified IP address.
Type The type of the dynamic entry.
IPv4/IPv6 Address The IP address associated with the host name.
To Next Page
Loading...
Need help?
General