18
Pause Time
Step-by-step
Function.
Motor
speed
FLASH:
10 seconds
20 seconds
40 seconds
80 seconds
Open – stop – close - stop
Open - stop - close- open
Condominium operation
Man present
Very slow
Slow
Medium
Fast
Output Open door indicator
Flashing light
Electric lock
Suction cup
7.2.3) Level two functions (adjustable parameters)
Table 17: programmable function list: level two
Input LED Parameter LED (level) value Description
Adjusts the pause time, namely the time which
lapses before automatic closure. This will only
have an effect if automatic closing is active
Manages the sequence of controls associ-
ated to the Step-by-Step input or to the
1st radio command (see tables 7 and 8).
Adjusts the speed of the motor during nor-
mal travel.
Selects the device connected to the
FLASH output
Note: “ ” represents the factory setting
All the parameters can be adjusted as required without any con-
traindication; only the selection of the device connected to the
“FLASH” output could require special care:
Before connecting the device to the “FLASH” output,
ensure that the correct function has been programmed. Oth-
erwise there is a risk of damage to the device.
L1
L2
L3
L4
7.2.4) Level two programming (adjustable parameters)
The adjustable parameters are factory set as shown in the table 17 with “ ” However, they can be changed at any time, as shown in Table
18. Follow the procedure carefully as there is a maximum time of 10 seconds between pressing one key and another. If more time lapses,
the procedure will finish automatically and memorize the modifications made up to that stage.
1. Press the key [Set] and hold it down (approx. 3 s)
3s
2. Release the [Set] key when L1 LED starts flashing
L1
3. Press keys [s] or [t] to move the flashing LED to the “input LED”
which represents the parameter which is to be modified. o
4. Press the key [Set],
and hold it down during step 5 and 6
5. Wait approx. 3 seconds, after which the LED representing the current level
of the parameter which is to be modified will light up.
6. Press keys [s] or [t] to move the LED which represents the parameter value.
o
7. Release the key [Set]
8. Wait 10s to exit programming on elapse of the maximum time interval.
10s
Note: Points 3 to 7 can be repeated during the same programming phases in order to adjust other parameters
Table 18: changing the adjustable parameters Example
L1
L2
L3
L4
L1
L2
L3
L4
L1
L2
L3
L4
L1
L2
L3
L4
7.2.2) Level one programming (ON-OFF functions)
Level 1 functions are all factory set to “OFF”. However, they can be changed at any time as shown in Table 16. Follow the procedure care-
fully, as there is a maximum time of 10 seconds between pressing one key and another. If a longer period of time lapses, the procedure will
finish automatically and memorize the modifications made up to that stage.
1. Press the key [Set] and hold it down (approx. 3 s)
3s
2. Release the [Set] key when L1 LED starts flashing
L1
3. Press keys [s] or [t] to move the flashing LED onto the LED representing the function
which is to be changed o
4. Press the [Set] key to change function status
(short flash = OFF; long flash = ON)
5. Wait 10 seconds before leaving the programme to allow the maximum time to lapse
10s
Note: Points 3 and 4 can be repeated during the same programming phases in order to set other functions to ON or OFF.
Table N°16: changing ON-OFF functions Example
To Next Page
Loading...
Need help?
General
