NVIDIA Jetson TX2 NX DG-10141-001_v1.1 | 4
Chapter 2. Jetson TX2 NX
The Jetson TX2 NX module resides at the center of the embedded system solution and
includes the following:
Power (PMIC/Regulators, etc.)
DRAM (LPDDR4)
eMMC
Gigabit Ethernet Controller
Power Monitor
In addition, a wide range of interfaces are available at the main connector for use on the
carrier board as shown Table 2-1 and Figure 2-1.
Table 2-1. Jetson TX2 NX Interfaces
USB
USB 2.0 Interface (3x)
CAN 1x
USB 3.0 (1x) LAN Gigabit Ethernet
PCIe PCIe (1 x1 + 1 x2) I2C 4x
Camera
CSI (3 x4 or 2 x4 + 2 x2, 1 x4 + 4 x2, or 5 x2), Control,
Clock
UART 3x
Display
eDP/DP
SPI 2x
HDMI/DP Interface (w/CEC) Fan FAN PWM and Tach Input
DSI (1, 2-lane), Display/Backlight Control Debug UART
Audio I2S Interface (4x) and Clock System Power Control, Reset, alerts
SD Card/SDIO SD Card or SDIO Interface (1x) Power Main Input and battery back-up for RTC
To Next Page
Loading...
Need help?
General
