Nvidia Jetson TX2 NX User Manual

Module Connector
NVIDIA Jetson TX2 NX DG-10141-001_v1.1 | 10
4.3 Module Installation and Removal
To install the Jetson TX2 NX module correctly, follow the sequence and mounting hardware
instructions:
Here are some suggested assembly guidelines.
1. Assemble any required thermal solution on the module.
2. Install the Jetson TX2 NX module
a). Baseboard with suitable standoff for as per SODIMM connector height defined.
b). Insert module fully at an angle of 25-35 degree into the SODIMM connector.
c). Arc down the module board until the SODIMM connector latch engages.
d). Secure the Jetson TX2 NX module to the baseboard with screws into the
standoff/spacer. The developer kit (shown in Figure 4 2) uses a standoff and screws to
secure the module to the system/base- board.
Figure 4-2. Module to Connector Assembly Diagram
To remove the Jetson TX2 NX module correctly, follow the reverse of the installation sequence.

Nvidia Jetson TX2 NX Specifications

General

Brand	Nvidia
Model	Jetson TX2 NX
Category	Computer Hardware
Language	English