C6100 Series User’s Guide
153
Shading on unprinted sections
Toner rubs off when you rub the printed
surface.
Ultra Heavy
If the Ultra Heavy setting does not give proper toner fusion,
you can try the Label settings.
Possible cause Remedy
Paper has been
affected by static
electricity.
Store paper within specified temperature and
humidity levels. See “Specifications” on
page 122.
Paper is too thick. Use recommended paper. See “Paper (Print
Media)” on page 10.
Toner is low. Replace toner cartridge. See “Replace a Toner
Cartridge” on page 73.
Possible cause Remedy
Media Weight and
Media Type settings
may not be
appropriate.
Set the value of media weight in the menu to
the next heaviest one (MEDIA MENU → YYY
MEDIA WEIGHT).
Packing materials were
left on the fuser when
it was installed.
Careful! Fuser my be HOT!
Open the top cover and check to be sure that
all the packing materials were removed from
the fuser. See “Replace the Fuser” on page 87.
To Next Page
Loading...
Need help?
General
