5-2 Connecting to the Host Using Controller Link
5-16
Required Devices
To construct a Controller Link Network, the devices described in the following table are re-
quired.
Device Model Remarks
Controller Link Unit CVM1-CLK21
C200HW-CLK21
CS1W-CLK21
CQM1H-CLK21
CJ1W-CLK21
Required to connect PLC
with Controller Link Net-
work.
Controller Link Support
Board (ISA Bus/PC98)
3G8F5-CLK21
3G8F6-CLK21
Controller Link Support
Board (PCI Bus)
3G8F7-CLK21
Required to connect IBM
PC/AT or compatible com-
puters with Controller Link
Network.
Twisted-pair Cable ESVC0.5×2C Required to connect the
PT, PLC, and IBM PC/AT
or compatible computers.
Use shielded twisted-pair
cable.
Controller Link Wired
Relay Terminal Block
CJ1W-TB101 Used as a relay terminal
block for wires and can be
used as required to facili-
tate replacement and
maintenance of Controller
Link Units and Boards after
the communications sys-
tem has been started.
5-2-2 Host Type and Settings
The CPU Units that support the Controller Link are listed in the following table.
PLC CPU Unit Controller Link
Unit
CS1 PLCs All models CS1W-CLK21
CJ1 PLCs All models CJ1W-CLK21
C200HX
C200HG, C200HE
PLCs（*1）
C200HX-CPU64/54/44/34-(Z)E
/65-Z/85-ZE
C200HG-CPU63/53/43/33-(Z)E
C200HE-CPU42/32-(Z)E
C200HW-CLK21
CQM1 PLCs CQM1H-CPU61/51 CQM1H-CLK21
CV500, CV1000,
CV2000
PLCs（*2）
All models CVM1-CLK21
CVM1 PLCs（*2） All models CVM1-CLK21
*1: One of the following is necessary to connect a Controller Link Unit.
C200HW-COM01/04 Board
C200HW-CE001/002/012 Bus-connecting Unit
*2: Routing tables are required if any of the CVM1/CV-series CPU Units in the network have been
manufactured on or before April 1996. The manufacturing data can be determined from the lot
number on the side of the CPU Unit.
Indicates the last digit of the
manufacturing year. In this example,
the year is 1996
……...Manufactured in April 199664
@@
Lot No.:
Indicates the month of manufacture.
October, November, and December
are indicated by x, y, and z
res
To Next Page
Loading...
Need help?
General
