6-5 Setting Passwords
6-23
6-5 Setting Passwords
NS-series PTs can be set to request a password for operating functional objects. The pass-
words are set from the NS-Designer and up to five passwords can be set for a single project.
The passwords cannot be changed from the System Menu.
Change passwords using the following procedure from the System Menu.
1. Select the Password Tab.
2. Select the password to be changed using the Level 1 to Level 5 Buttons.
3. Input the old password and new password in the corresponding fields, and then input the new
password again in the confirmation field. Input the password using the virtual keyboard (text in-
put dialog box) that is displayed by pressing the input column.
4. After changing the password, press the Write Button to save the setting. Save separately for
each password level that is changed.
Note When changing passwords, do not reset the PT or turn OFF the power until the write opera-
tion has been completed (i.e., the Write Button has returned to the status before being
pressed). If the password is not saved properly, the screen may malfunction.
If the password is forgotten, it cannot be checked from the PT. Check the password using
the NS-Designer.
To Next Page
Loading...
Need help?
General
