Omron NS7 Series User Manual

2-2 Part Names and Functions
2-8
NS12/NS10 Rear Panel Switches
Note: The 5-V output of serial ports A and B cannot be used at the same time.
Note Confirm system safety before turning the power ON/OFF or restarting. Otherwise the system
may operate unpredictably.
Reset Switch
Used to initialize the PT.
The status of screen data, other registered data,
and memory switches, however, will not change.
Serial Port A Connector (See note.)
Used to connect the host, NS-Designer, and
Bar Code Reader. Uses an RS-232C 9-pin
connector.
Serial Port B Connector (See note.)
Used to connect the host, NS-Designer, and Bar
Code Reader. Uses an RS-232C 9-pin
connector.
Ethernet Connector
Used to connect the Ethernet cable. Uses
a 10Base-T 8-pin modular plug.
Battery Cover
The battery is installed
underneath the cover.
Main circuit DC Input Terminal
Used to connect the power
supply.
FG Terminal
Used to prevent malfunctions
due to noise interference.
Expansion Memory Board Cover
Used to expand the screen data.
Open the cover and install the
Expansion Memory Board in the
slot.
DIP Switch
Used to set the settings for
transmitting data using the
Memory Card.
Expansion Interface Connector
Used to mount the Video Input
Unit or the Controller Link
Interface Unit.
Memory Card Connector
Used to connect the memory
card for storing and transmitting
screen data, log data, and
system programs.

Omron NS7 Series Specifications

General

Brand	Omron
Model	NS7 Series
Category	Touch terminals
Language	English