To Next Page

To Previous Page

5-34 ABORT

Aborts the process being performed by the PC and enables reception of the next

command. There is no response.

Command Format

@ XZ

Unit no. FCS TerminatorHeader

code

x 10

Note The PC requires 100 ms between reception of the ABORT command and the

following command.

5-35 Response to an Undefined Command

This response is sent if the PC cannot decode the header code of the command.

If this response is received, check the header code that was sent in the previous

command block.

Response Format

@ IC

Unit no. FCS TerminatorHeader

code

x 10

5-36 INITIALIZE

Initializes all Units in the network. This command does not required the node

number or an FCS. No response format involves. It is possible to use this com-

mand only when the PC is mounted with the Host Link Unit.

Note Do not sent the node number or an FCS with the INITIALIZE command.

Caution This command is supported only by CPUs of version 2 or later or by Host Link

Units.

INITIALIZE Section 5-36

Omron SYSMAC CV1000 User Manual

Other manuals for Omron SYSMAC CV1000