Omron SYSMAC CV1000 User Manual

77
Response Format
@ CR
Unit no. FCS TerminatorHeader code Data from beginning wordResponse
code
Data
*s
x 10
0
x 10
1
x 16
1
x 16
0
x 16
3
x 16
2
x 16
1
x 16
0
Parameters Data (response): The data of the eight words will be read in the hexadecimal.
5-10 CIO AREA WRITE
Writes data to the CIO area starting from the specified word. The data to be writ-
ten is specified word by word.
Command Format
@ WR
Unit no. Beginning word FCS TerminatorHeader code Data for beginning word
Data
*s
x 10
0
x 10
1
x 10
3
x 10
2
x 10
1
x 10
0
x 16
3
x 16
2
x 16
1
x 16
0
Response Format
@ WR
Unit no. FCS TerminatorHeader
code
Response
code
*s
x 10
0
x 10
1
x 16
1
x 16
0
Parameters Beginning word (command): Specify in BCD the address of the first word to be
written to in the CIO Area (0000 through 2555).
Data (command): Specify the data to be written in hexadecimal.
Note The boundary of the data area must not be exceeded. For example, if you speci-
fy CIO 2555 for the beginning word and try to write more than one word, an error
will result and no data will be written.
5-11 LINK AREA WRITE
Writes data to the specified number of Link Area words (CIO 1000 to CIO 1063),
starting from the specified offset from the beginning of the area. This command
will be processed properly regardless of whether or not the Link Area is actually
set for use as data link words.
Command Format
@ WL
Unit no. Beginning word FCS TerminatorHeader code Data for beginning word
Data
*s
x 10
0
x 10
1
x 10
3
x 10
2
x 10
1
x 10
0
x 10
3
x 10
2
x 10
1
x 10
0
Response Format
@ WL
Unit no. FCS TerminatorHeader
code
Response
code
*s
x 10
0
x 10
1
x 16
1
x 16
0
LINK AREA WRITE Section 5-11

Omron SYSMAC CV1000 Specifications

General

Brand	Omron
Model	SYSMAC CV1000
Category	Controller
Language	English