37
Front Panel≫ Rear Panel≫ Remote≫
Contents
≫
Connections
≫
Playback
≫
Setup
≫
Connecting an AV Component in a Separate Room (Multi-zone Connection)
Connecting a Pre-main Amplier (ZONE 2)
You can enjoy 2-ch audio in the separate room (ZONE 2) while performing 7.1-
ch playback in the main room (where this unit is located). Use an analog cable
to connect the ZONE 2 LINE OUT jack of this unit and the LINE IN jack of the
pre-main amplier in the separate room. The same source can be played back in
the main room and ZONE 2 simultaneously. Also, dierent sources can be played
back in both rooms.
• To output audio from an externally connected AV component to ZONE 2, use
either a digital coaxial cable, digital optical cable or analog audio cable for
connection. Also, the audio from externally connected AV components can be
output to ZONE 2 only when the audio is analog or 2ch PCM signal. When
the AV component is connected to this unit with a digital coaxial cable or
digital optical cable, change the audio output of the AV component to the PCM
output.
a Analog audio cable, b Digital coaxial cable
a
LINE
IN
OR
a b
BD/DVD
Premain Amp.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
