Hot Swappable CRUs
3-6 StorageTek SL150 Modular Tape Library Customer Replaceable Unit Guide
3. Pull the magazine free of the module and set it aside.
To Replace a Tape Cartridge Magazine
Caution: Although the magazine contains cartridge retention
springs, use care when holding or moving the magazine to avoid
unseating or dropping cartridges.
1. Orient the magazine with the cartridge slots facing toward the center of the
module.
2. Lift the magazine and point the back of it toward the module slot.
3. Engage the magazine with the track in the magazine bay of the module.
4. Verify all tapes are properly seated in the magazine slots.
5. Push the magazine fully into the library module.
6. From the Library list, select Lock and Audit.
Note: Code levels before 2.25 do not have the Lock and Audit
command.
7. Select the Set the Library back online after applying this action check box in the
Lock and Audit dialog box.
8. Click OK.
Hot Swappable CRUs
This section provides removal and replacement instructions for the tape drive tray and
power supply CRUs that you can replace while power is applied to the library. You
temporarily remove the power supply or drive tray assembly and then insert the
corresponding CRU in the open slot.
Warning: Do not operate the library with open tape drive or
power supply slots.
Drive Tray Assembly
The drive tray assembly (drive tray) is located in the center, rear of the module (see
Figure 3–1). The drive tray has a series of indicators on the back panel (see Figure 3–8),
an exposed circuit card near the right side thumbscrew, a tape drive, and a chassis
(alsoreferredtoasasled).
To Next Page
Loading...
Need help?
General