Other CRUs
Removal and Replacement 3-15
To Remove the Front Control Panel
1. Power down the library (see "To Perform a Controlled Power-Down from the GUI"
on page 3-11).
2. Remove both cartridge magazines from the base module (see "To Remove a
Cartridge Magazine Manually" on page 3-13).
3. Press the latch inside each magazine bay inner wall and pull the bottom edge of the
panel away from the module until the panel is unlatched (see Figure 3–15).
4. Free the tabs on the top edge of the panel from the module.
5. Rotate the top edge of the panel away from the top of the module about 90 degrees
and hold the panel in this position with one hand.
6. Disconnect the ribbon cable plug from the jack located on the circuit card (see
Figure 3–16).
7. Set the panel CRU on the anti-static mat.
Figure 3–15 Front Control Panel Side View
Figure 3–16 Front Control Panel Jack
To Next Page
Loading...
Need help?
General