Version 4.7/4.92/5.12
70 | Appendix A
Magellan & Spectra SP • Programming Guide
Keypad Lockout
Use the following section to program keypad lockout settings for your MG/SP control panel. Use worksheet 30 to record your settings.
NOTE: For EN 50131, the keypad lockout value must be set between three and ten attempts. The minimum delay to lock must be two minutes.
Dialer Options
Timers
Use worksheet 38 to record your settings for sections [820] to [840].
Special notes for MG5050
The Installer Quick Menu is not available anymore for MG5050 V4.96 or higher.
Section [820] (Fail to comm. clear event timer) is not available anymore for MG5050 V4.9 or higher.
Worksheet 57: Keypad Lockout
Section Data Description Default
[716] ___/___/___ 000 to 255 minutes Keypad lockout delay 015 minutes
[717] ___/___/___ 000 to 255 attempts before locking Keypad lockout counter 005 attempts
Table 65: Description of section [801]
Option Description OFF ON
Section [801]
1 Report system disarming
Always After alarm
2 Report zone restore on closure
Bell cutoff Zone closure
3 & 4 Auto-test report transmission Disabled
Enabled
5Contact ID override Disabled
Enabled
6 Future use
7 Future use
8 Future use
= Default
Worksheet 58: Communication Timers
Section Data Description Default
[820] ___/___/___ 000 to 255 hours Fail to comm. clear event timer (does not apply to SP4000 and SP65) 000 = disabled
[830] ___/___/___ 000 to 255 x 2 seconds TLM fail delay (landline only) 016
[831] ___/___/___ 000 to 032 Maximum dialing attempts monitoring station (landline and GSM only) 002
[832] ___/___/___ 000 to 127 seconds Delay between dialing attempts* (landline and GSM only) 020
[833] ___/___/___ 000 to 255 seconds Delay alarm transmission 000
[834] ___/___/___ 000 to 127 seconds Pager reporting delay 020
[835] ___/___/___ 000 to 010 Pager reporting message repetition 003
[836] ___/___/___ 000 to 127 seconds Personal reporting delay* 005
[837] ___/___/___ 000 to 010 Personal reporting message repetition* 003
[838] ___/___/___ 000 to 255 seconds Recent closing delay 000
[839] ___/___/___ 000 to 255 minutes Power failure report delay** 015
[840] ___/___/___ 000 to 255 days Auto test report (see table 37 on page 42) 001
* Also applicable when using a VDMP3 Plug-in Voice Dialer.
**The maximum value for power failure is 60 minutes.