Engine oil level
In 4T engines, engine oil is used to lubricate the timing system elements, main bear-
ings and thermal group. An insufficient quantity of oil can seriously damage the
engine. In all four-stroke engines, a loss of efficiency in oil performance and certain
consumption should be considered normal. Consumption can particularly reflect the
conditions of use (i.e. when driving at 'full acceleration' all the time, oil consumption
increases). The replacement intervals provided for by the maintenance programme
are defined depending on the total content of oil in the engine and the average con-
sumption measured following standardised methods. In order to prevent any prob-
lems, we recommend checking oil level more frequently than indicated in the
Scheduled Maintenance table or before setting off on long journeys. The vehicle
is, however, equipped with an oil pressure warning light on the instrument pan-
el.
03_01
Engine oil level check (03_01, 03_02)
Each time you use the vehicle, when the engine is cold, you must check engine oil
level. To check engine oil level, proceed as follows:
1. Rest the vehicle on its centre stand on an even surface.
2. Unscrew the engine oil dipstick "A", dry it with a clean cloth and then put it
back,screwing it down completely.
3. Pull the dipstick out and check that the oil level is between the MAX and MIN
levels indicated on the dipstick.
4. Screw the oil dipstick back into place completely.
If the check is carried out after the vehicle has been used, and therefore with a hot
engine, the level line will be lower; in order to carry out a correct check, wait at least
10 minutes after the engine has been stopped so as to get the correct level.
58
To Next Page
Loading...
Need help?
General