Point Mobile PM260 User Manual

specified period of time. You can set this time period in the Power setting.
To suspend and resume operation, press the Power button. You may also press the front Scan key
to wake a suspended device unless the battery door has been removed and replaced.
☞NOTE:
You should always put the terminal in Suspend Mode when you change the battery pack; see Changing the
Main Battery Pack on paragraph 4.18. When you replace the battery door, press the
Power
button to wake the
device.
Pressing the front Scan key will not wake up the device when the battery door is replaced.
Troubleshooting Suspend/Resume
If the terminal does not wake when you press the Power button, the main battery might be too low
to resume operation. To check, remove the battery and install a fully charged battery or connect the
terminal to a Handy Terminal charging peripheral.
4.24. Memory Allocation
You can verify file storage and program memory in System Properties.
1. Tap Start -> Settings -> Control Panel -> System -> Memory tab.
4.25. Care and Cleaning of the Products
When needed, clean the image engine window and the LCD display with a clean, non-abrasive, lint-
free cloth. The terminal can be cleaned with a damp cloth.
4.26. PM260 Technical Specifications
Model PM260
Operating System Microsoft Windows Embedded CE 6.0 Pro
Development
Environment
HT_SDK_Vxxx.msi
Application Software Tools and Demos
Processor Marvell® PXA 300 624MHz
31

Point Mobile PM260 Specifications

General

Brand	Point Mobile
Model	PM260
Category	Handhelds
Language	English