Wireless Radios (Wireless Communication)
HANDY TERMINALs can be equipped with an 802.11b/g/n and Bluetooth radio.
For more information, see Wireless Radios on paragraph 10.14.
10.2.
Handy Terminal is shipped with the operating system, radio drivers, and custom software (CICO)
already installed. These are the default programs that install when your terminal first boots up. You
can install additional software programs on the terminal provided that the following parameters are
met:
• The software program was created for a Windows CE device.
• The terminal has enough memory to store and run the program.
• The program has an EXE, CAB, or DLL extension.
When selecting programs, verify that the program and version of the program are designed for the
Windows Embedded CE 6.0 Pro and the terminal’s processor. You can verify your processor by
tapping Start -> Settings -> Control Panel -> System -> General tab. Make a note of the
information in the Processor field.
To install additional software, you can use the communication options described in this chapter.
• Adding Programs via ActiveSync (paragraph 10.13).
• Adding Programs from the Internet (paragraph 10.17).
10.3.
To facilitate USB communication between the Handy Terminal and the host workstation, you may
connect your unit to a host by using either the USB ActiveSync cable, the optional Single Slot
Docking Cradle or the optional Single Slot Ethernet Cradle. If you use the Communication Cable,
slide the cable unit onto the bottom of the terminal lining up the terminal’s I/O connector with the
cable unit’s connector.
52
To Next Page
Loading...
Need help?
General
