3
9850068 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual
© Copyright Polaris Industries Inc.
3.47
16.Remove two fasteners
o
and remove the lower turbo
heat shield. There is a third fastener in the center of
the turbo housing.
17.Remove six fasteners
a
retaining the head pipe to
the cylinder head.
18.Slide the head pipe off the studs and remove the
head pipe/turbo from the vehicle.
CAUTION
Do not handle the turbo/head pipe assembly by the
actuator rod. The rod will become damaged and the
turbo will not function properly.
19.Remove two hoses going to the charge air cooler and
move the hoses towards the front of the vehicle.
20.Remove thermostat housing hose
s
and water pump
hose
d
.
21.Disconnect stator harness and disconnect the
harness retainer from the engine mount.
22.Disconnect TBAP, both TMAP sensors, CPS, coolant
temp sensor, Trans switch, speed sensor, injectors,
ETC.
23.Remove zip ties retaining electrical harnesses and
transmission vent line to intake manifold
f
.
ENGINE / COOLING SYSTEM
To Next Page
Loading...
Need help?
General
