7.28
9926816 R07 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.
FRONT PROP SHAFT INSTALLATION
1. Reverse the appropriate Front Propshaft Removal,
page 7.27 procedure to reinstall the front propshaft.
2. Lubricate front gearcase shaft splines with Anti-
Seize.
3. Lubricate the front and rear prop shaft mid joint with
Polaris All Purpose Grease.
4. Align the front and rear prop shafts as shown below
and slide them together.
NOTE
Paint marks are applied to the front and rear prop shafts
to aid shaft alignment. Reference these marks during
installation if still visible.
5. When installing the front prop shaft onto the front
gearcase, use a new roll pin.
6. Reposition the front gearcase and install the four
bolts that secure the front gearcase to the frame.
Torque bolts to specification.
TORQUE
Front Gearcase Mounting Bolts:
30 ft-lbs (41 Nm)
REAR PROP SHAFT REMOVAL
1. Remove the center console.
q
Cap
e
Torx Screw
w
Shifter
r
Push Rivet
2. Remove the two fasteners
t
retaining the support
bearing cover
y
to the frame.
3. While moving the prop shaft support bearing
assembly, slide the rear prop shaft towards the rear
until the front prop shaft yoke disengages from the
splines.
FINAL DRIVE
To Next Page
Loading...
Need help?
General
