Polaris RZR XP 1000 2015 Service Manual

2.10
9926816 R07 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.
ENGINE
ENGINE OIL LEVEL
This engine has a wet-sump design, meaning the engine
oil is contained in the bottom of the crankcase. To check
the oil level, follow the procedure listed below:
Access the oil dipstick through the opening in front of the
passenger rear tire.
Access the oil fill cap through the cargo box access
panel.
Polaris recommends the use of PS-4 Synthetic or PS-4
Extreme Duty Synthetic 4-Cycle Engine Oil.
FLUID CAPACITY
Recommended Engine Oil:
Capacity: 3.0 qt (2.8 L)
PS-4 Full Synthetic 5W-50
Ambient Temp Range: -35° F to 100° F
PS-4 Extreme Duty
Ambient Temp Range: 0° F to 120° F
1. Position vehicle on a level surface and place the
transmission in PARK.
2. Stop the engine and allow it to cool down before
removing the dipstick.
3. Unlock the dipstick lever
q
. Remove the dipstick and
wipe it dry with a clean cloth.
4. Reinstall the dipstick and push it into place. Do not
lock the dipstick
NOTE
Make certain the dipstick is inserted all the way into the
dipstick tube to keep the depth of the dipstick
consistent.
5. Remove the dipstick and check the oil level.
6. Add the recommended oil as necessary to bring the
oil level within the SAFE range on dipstick. Do not
overfill (see NOTE below).
NOTE
A rising oil level between checks during cold weather
operation can indicate contaminants such as gas or
moisture collecting in the crankcase. If the oil level is
over the upper mark, change the oil immediately.
7. Add engine oil through the oil fill cap
w
located on
top of the valve cover, under the cargo box access
panel.
8. When finished, reinstall dipstick and lock the lever.
MAINTENANCE

Polaris RZR XP 1000 2015 Specifications

General

Brand	Polaris
Model	RZR XP 1000 2015
Category	Offroad Vehicle
Language	English