Polaris RZR XP 1000 2015 Service Manual

7.30
9926816 R07 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.
7. Torque the support bearing fasteners to
specification.
TORQUE
Support Bearing Fasteners:
35 ft-lb (47 Nm)
8. Align the front prop shaft paint mark with the front
gearcase input shaft mark so the pin holes align.
Install a new roll pin.
REAR PROP SHAFT REMOVAL XP 4
1. Remove all seats.
2. Remove the front and rear center consoles (see
Chapter 10 – Rocker Panels, Rear Console and Floor
XP 4, page 10.24).
3. Remove the fasteners
q
from center
w
and rear skid
plates
e
.
4. Remove center and rear skid plates.
5. Remove the fasteners
r
securing the support
bearing cover
t
to the frame.
6. Move the prop shaft support bearing assembly to the
drivers side to slide the rear prop shaft yoke
y
off the
transmission output shaft.
FINAL DRIVE

Polaris RZR XP 1000 2015 Specifications

General

Brand	Polaris
Model	RZR XP 1000 2015
Category	Offroad Vehicle
Language	English