Polaris RZR XP4 1000 2017 User Manual

6.6
9928492 R04 - 2017-2018 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.
4. The gap between the shifter guide
y
and the gated
plate
u
should be the same on both sides.
NOTE
The center console is not shown for visual purposes.
This work may be performed with the center console
installed.
5. If the gaps are not equal, loosen the four bracket bolts
i
. Move the bracket until the gaps are equal and
tighten the fasteners to specification.
TORQUE
Gated Shifter Bracket Fasteners:
14 ft-lb (19 Nm)
6. Install the shifter boot, spacer, shift knob, retaining
screw and shift knob cover.
SHIFT CABLE INSPECTION
Shift cable adjustment may be necessary if symptoms
include:
• No gear position or AWD display on instrument cluster
• Ratcheting noise on deceleration
• Inability to engage into a gear
• Excessive gear lash (noise)
• Gear selector moving out of desired range
Inspect shift cable, clevis pins, and pivot bushings and
replace if worn or damaged.
SHIFT CABLE ADJUSTMENT
1. Locate the shift cable attached to the transmission
case in the right rear wheel well area.
2. Inspect shift cable
q
, clevis pin, pivot bushings, and
dust boot
w
. Replace if worn or damaged.
TRANSMISSION

Polaris RZR XP4 1000 2017 Specifications

General

Brand	Polaris
Model	RZR XP4 1000 2017
Category	Automobile
Language	English