Polaris RZR XP4 1000 2017 User Manual

7
9928492 R04 - 2017-2018 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.
7.23
SUPPORT BEARING REPLACEMENT
1. Remove the rear prop shaft from the vehicle (see
Chapter 7 – Rear Prop Shaft Removal, page 7.21).
2. Using a rubber mallet, remove the rubber isolated
bearing support from the shaft to expose the bearing.
3. Using a commercially available 2-jaw puller, remove
the bearing from the end of the prop shaft.
4. Clean the bearing mounting surface on the shaft and
apply Loctite
®
603
™
retaining compound to the
clean surface.
5. Install the new support bearing assembly onto the
end of the prop shaft.
6. Using an appropriate bearing/bushing installation
sleeve, drive the support bearing assembly onto the
prop shaft until it seats against the shoulder on the
shaft.
NOTE
Only drive on the inner race of the bearing. Driving on
the bearing in any other location will damage the
bearing.
7. Wipe the bearing and shaft clean of any excess
retaining compound.
NOTE
Do not allow any Loctite
®
to get in the bearing.
8. Install the rear prop shaft into the vehicle (see
Chapter 7 – Rear Prop Shaft Installation, page 7.25).
FINAL DRIVE

Polaris RZR XP4 1000 2017 Specifications

General

Brand	Polaris
Model	RZR XP4 1000 2017
Category	Automobile
Language	English