4. Configure the following settings:
Setting Description
Link-Local Specifies the IPv6 address to use for local communication
within the subnet.
Site-Local Specifies the IPv6 address to use for communication
within the site or organization.
Global Address Specifies the IPv6 internet address.
Default Gateway Specifies the default gateway assigned to your system.
5. Select Save.
Manually Assign a Host Name and Domain Name
You can manually enter the host name and domain name for your TC10 device. You can also modify
these settings even if your network automatically assigns them.
1. In the device local interface, go to Settings > Network.
2. Enter or modify the device Host Name.
If the device discovers a valid name during setup or a software update, the device automatically
creates the host name. However, if the device finds an invalid name, such as a name with a
space, the device creates a host name using the following format: DeviceType-xxxxxx, where
xxxxxx is a set of random alphanumeric characters.
3. Enter or modify the Domain Name that the device belongs to.
4. Select Save.
Manually Configure DNS Settings
You can manually enter the DNS settings for your device.
1. In the device local interface, go to Settings > Network.
2. Turn the Obtain Automatically Using DHCP setting off.
3. Enter the DNS server addresses your device uses (you can enter up to four addresses).
4. Select Save.
Enable LLDP on Your Poly TC10
You can configure your Poly TC10 to automatically select VLAN settings using LLDP.
The VLAN ID of the TC10 must match the VLAN ID of the system for system pairing to be successful.
NOTE: VLAN isn’t supported in IPv6 environments.
1. In the device local interface, go to Settings > Network.
2. Select the LLDP toggle button to turn the setting on.
The TC10 automatically assigns a value to VLAN ID based on your network configuration.
14
Chapter 3Setting Up the Poly TC10
To Next Page
Loading...
Need help?
General
