3. Select Save.
Configure Poly TC10 VLAN Settings
You can configure the TC10 virtual LAN (VLAN) settings.
The VLAN ID of the Poly TC10 must match the VLAN ID of the system for system pairing to be
successful.
NOTE: VLAN isn’t supported in IPv6 environments.
1. In the device local interface, go to Settings > Network.
2. Select the 802.1p/Q check box and enter a VLAN ID.
The ID specifies the VLAN that you want the Poly TC10 to operate on. You can use values from
1 to 4094.
3. Select Save.
Manually Pair the Poly TC10 with a Video System
You can manually pair the Poly TC10 connected to your primary network with a video system in the
room.
To pair, the Poly TC10 must be on the same subnet as the video system and the following network
components unblocked:
● Multicast address 224.0.0.200
● UDP port 2000
● TCP port 18888
You may see multiple devices that you can pair with on your video system’s Device Management
page. Know the MAC address to ensure you’re pairing with the device you want such as the device in
the room you’re setting up.
1. Connect the Poly TC10 that you want to pair to an Ethernet port in the room.
2. In the system web interface, go to General Settings > Device Management.
3. Under Available Devices, find the device by its MAC address such as 00e0db4cf0be and select
Pair.
If paired successfully, the device displays under Connected Devices with a Connected status. If
a device shows a Disconnected status, the pairing wasn’t successful.
If pairing isn’t successful, check the network connection and the configuration of both the Poly TC10
and the system you want to pair it with.
Configure Poly TC10 VLAN Settings
15
To Next Page
Loading...
Need help?
General
