Matrix 424/832/832+ LCD Programming Manual
Page 4 RINS916-6
1. ENGINEER MENU SYSTEM
1.1 Entering Engineers Mode
¾ Enter Engineer mode by pressing () (default engineer code - 9999).
¾ Press . 'Engineers Mode' will be displayed.
Note: Engineer mode can only be entered if all partitions are disarmed.
1.2 Exiting Engineers Mode
¾ Press then . If any tampers are active, then these will be displayed on the keypad.
¾ Press then to exit engineers mode.
1.3 Entering Engineer Menu
NOTE: The Engineer Menu is currently only available on UK LCD keypads.
¾ In Engineers Mode, Press the key.
1.4 Exiting Engineer Menu
¾ Press the key. Note: You must not be in an active function.
1.5 Testing Partitions
A test facility for all partitions is available in Engineers Mode. To enter this function, once in Engineers
Mode, enter the Engineers Code again. The partition test facility will be displayed.
M
AKE SURE ALL PARTITIONS ARE DISARMED BEFORE EXITING ENGINEERS MODE.
1.6 Navigating the Menu
¾ The menu structure is shown below. Use the and keys to navigate through the menu.
1.6.1 Menu Sections
All menu entries starting with a
►
symbol sub-menu headings. To enter a sub-menu press the key.
Functions within the sub-menus are indicated by a
>
symbol. Press the key to run the function.
When a menu function has been completed you will be returned to the engineer menu.
1.7 Initial Power up
On initial power up the LCD keypad will display the address. This will be shown as ‘Matrix Keypad ID
[1]’, the number in the brackets indicate the address of the keypad, to change this you must select the
correct address from the dip switches – as shown in the installation manual.
1.8 Menu Structure
Menu Section Sub-Section Equivalent Function
►SYSTEM OPTIONS >SYSTEM OPTIONS 1
>SYSTEM OPTIONS 2
>SYSTEM OPTIONS 3
►ZONES >CONNECTIONS
>ZONE TYPE
>ZONE TYPE – A
>ZONE TYPE – B
>ZONE TYPE – C
>ZONE TYPE – D
To Next Page
Loading...
Need help?
General
