Chapter 2: Installing the Chassis
Power On/Power Off
QX and QXS Setup Guide 87
Figure84:QXS-5600 AC power supply with power switch
Power Cycling Procedures
Power cycling procedures vary according to the type of power supply included within the chassis.
l For RAID chassis and expansion chassis configured with switchless AC power supplies, refer to the
procedure described in AC Power Supply below.
l For procedures pertaining to a) RAID chassis configured with DC power supplies, or b) previously
installed expansion chassis featuring power switches, see DC Power Supplies with Power Switch on
page 89.
AC Power Supply
RAID chassis and expansion chassis configured with switchless power supplies rely on the power cord for
power cycling. Power-on the chassis by connecting the cord from the power supply power cord connector to
the appropriate power source; power-off the chassis by disconnecting the cord from the power source.
To Next Page
Loading...
Need help?
General