68
HSB Series LCD Display
Controlling VRM/EBL Data Boxes
➤ To move a VRM/EBL data box, using the context-sensitive cursor:
1. Move the cursor over the box until the letters BOX are displayed, and press
ENTER to take cursor control of the box.
2. Use the trackpad to move the box to its new location, and press ENTER to
drop it and return to normal cursor operation.
Each VRM/EBL data box is switched on and off with its associated VRM/
EBL. However, when one or both VRM/EBLs are active, you can turn the data
box(es) off at any time, if required.
➤ To control the VRM/EBL data boxes:
1. Press VRM/EBL to display the VRM/EBL soft keys.
2. Press the VRM/EBL DATABOX soft key to toggle the setting from OFF to ON or
from ON to OFF.
3. Press ENTER.
Note: VRM/EBL data boxes are not affected by the setting of the
DATABOXES
soft key accessed using the
SCREEN
default soft key. This only controls the set of
data boxes available for integrated systems (see Chapter 2).
Controlling VRM/
EBL Data Boxes
To Next Page
Loading...
Need help?
General
