Using the Battery to Power Your Camcorder
The battery must be charged
as described
on
the next page
before it can be used the
first time. Initial charging will take
approximately 70 minutes. When fully
charged, the battery should supply about
45 minutes of operating time (depending
on how much you use zoom and pause).
When using the battery to power the
camcorder, turn the camcorder off during
recording breaks to conserve the
battery’s power. Slide the switch again
and press the thumb trigger when you are
ready to resume recording.
Note: The small marker switch on the top of
the battery is for use as a personal reminder
to help you remember to recharge the battery.
It has no other function.
WER
Switch and Indicator
Marker Switch
WARNING: NICKEL
CA?MIUM
BATTERY
MUST &E DISPOSED
OF PROPERLY.
RELEASE
Button
Attaching the Charged Battery Removing the Battery
If the power connector is attached to the Press and hold the
BATTERY RELEASE
camcorder, remove it before attaching the
button on the camcorder while sliding the
battery. Also, install the lithium clock
battery to the left and off the camcorder.
cell before attaching the battery pack.
Details on
page 30.- - -
1. Align the reference mark on the battery
with the mark on the back of the
camcorder.
2. Hold the battery flush against the
camcorder and slide it in the direction
of the arrow.
3. Slide the
POWER
switch to turn on the
camcorder. The
POWER
indicator will
light.
--
AlTENTION:
The product that you have purchased contains a rechargeable battery. AI the end of its useful lifwnder various slate
and local laws,it may be illegal (0 dispose of this battery into the municipal waste stream.Check with your local solid
waste officials for details in your area for recycling options or proper disposal.
J
17
To Next Page
Loading...
Need help?
General
