After the date, time, and ages have been set, they can be displayed and recorded on
your tapes. The clock cell must be installed.
CAMERA/Pm Y
Switch in
CAMERA
DATE/TIME ADJ. SET + and - Buttons
DATE/TIME ADJ. SELECT Button
DISPLAY Button.
POWER Switch
Install the clock lithium cell.
The clock cell indicator & will appear in the viewfinder when the cell has not been
installed or needs to be replaced. The cell should last approximately one year.
1. Make sure the camcorder is turned off,
and remove any power supply attached
to the camcorder.
2. Press the release tab of the clock cell
compartment cover and open the
compartment.
3. Insert the clock cell with the “+”
terminal facing out.
4. Close the compartment cover. It will
click into place.
30
To Next Page
Loading...
Need help?
General
