30
Playing Sources
Note:
If you switch on Midnight listening,
Loudness, or the Tone controls when
DIRECT is selected, the receiver automati-
cally switches to STEREO.
Listening to Multi-
Channel Playback
INPUT SELECTOR
CDTV/SATDVD/LD
RECEIVER
POWER
CD-R
TAPE/MD
VCR
DVR
TUNER
STANDARD
1 Turn on the playback component.
2 Turn on the receiver’s power.
3 Select the source you want to
playback.
Use the INPUT SELECTOR buttons on
the remote (or the MULTI JOG dial on
the front panel).
4 Press STANDARD.
For multi-channel sources, Dolby/DTS
decoding is selected automatically
according to the source and shows in the
display.
For a two channel source, you can press
STANDARD repeatedly to select the Pro
Logic II mode you want:
(Pro Logic II)
Music
Pro Logic
(Pro Logic II) Movie
Refer to “Standard Modes” on page 28 for
more details about each mode.
5 Start playback of the component
you selected in step 1.
Using Advanced
Surround
Dolby Pro Logic, Dolby Digital and DTS
signal processing is done automatically
corresponding to the input signal.
Press ADVANCED SURROUND
repeatedly to cycle the sound
options.
Each press changes the display as
follows:
Movie Music
5-Stereo
Expanded
Refer to “Advanced Surround Modes” on
page 28 for more details about each
surround effect.
Note:
The Movie, Music, and Expanded effects of
Dolby/DTS can be adjusted in the range of
10 to 90 (the default setting is 70) by
pressing
EFFECT +/– . The effect level can
be set for each of these Advanced Surround
modes. The Standard and Stereo modes
cannot be changed.
31_5021.RCA.28.32 03.3.17, 8:25 PM30
To Next Page
Loading...
Need help?
General
