RCA Professional series User Manual

Setting Up the Receiver
37
After you assign a component to the digital
jack, whenever you select that component,
for example a DVD player, the receiver
automatically changes to the digital input
setting and DIGITAL shows in the display.
Setting the Relative
Volume Level of Each
Channel
Default setting: 0 dB
For best surround sound playback, you
should set the relative channel levels from
the main listening position. You can set
seperate levels for each surround mode.
1 Press STANDARD.
2 Press TEST TONE to output the
test tone.
The test tone is output in the following
order (depending on the speaker setting):
FL C FR
SL
SW SR
Note:
If you do not hear a test tone from one of
your speakers, please refer to “Speaker
Setting” on page 34 to make sure you have
correctly specified your speaker setup.
3 Press MASTER VOLUME +/– to
adjust the volume to an appropri-
ate level.
4 Use LEVEL +/– to adjust the
speaker levels in turn.
You should hear the test tone at the same
volume from each speaker when seated in
the main listening position. The channel
level range is ± 10 dB.
5 When you are done, press TEST
TONE
to turn off the test tone.
Notes:
• Test tone is only output in Standard
modes.
• Since the subwoofer transmits an ultra-
low frequency its sound may seem
quieter than it actually is.
• The speaker volume can be adjusted
without outputting the test tone by
pressing CH SELECT and then using
LEVEL +/–.
CH SELECT
TEST
TONE
LEVEL
MASTER
VOLUME
STANDARD
31_5021.RCA.33.37 03.3.17, 8:25 PM37

RCA Professional series Specifications

General

Brand	RCA
Model	Professional series
Category	Receiver
Language	English