RCA Professional series User Manual

36
Setting Up the Receiver
Use  or  to set the distance of the
surround speakers from the main
listening position (within a 30 foot
range).
Note:
When
S is selected in the speaker setting,
the surround distance cannot be set.
Dynamic Range Control
Setting
Default setting: OFF
Dynamic range is the difference between the
loudest and softest sounds in any given
signal. With this setting, you can compress
the dynamic range, so that low level sounds
can be heard more easily (sounding
relatively louder) yet louder sounds will not
be too overbearing.
Press  or  to set the dynamic
range control (OFF, MAX, or MID).
Notes:
• When listening at low volumes, set to
MAX for maximum dynamic range
compression.
• Dynamic range control is effective only
when a Dolby Digital signal is being
played back.
Dual Mono Setting
Default setting: ch1
The dual mono setting can only be used
when listening to Dolby Digital discs with
dual mono encoding. These discs are not
widely used, but are sometimes used when
it is necessary to have one language on one
channel and a different language on the
other. With this setting you can choose
which channel in the dual mono setting you
want to listen to.
If Dolby Digital mode is switched on, you
will hear the channel you have selected
(either
ch1 or ch2) through your center
speaker. With Dolby Digital mode off, or if
you do not have a center speaker, you will
hear the channel you have selected through
both front speakers. In the L ch 1. R ch 2
setting, the left front speaker will play
channel 1 and the right front speaker will
play channel 2.
Use  or  to cycle through the
possible dual mono settings.
ch2
L ch 1.R ch 2
ch1
Coaxial Digital Input Setting
Default setting: DVD
Here you tell the receiver what component
you have connected to the coaxial digital
input jack.
Use  or  to select the coaxial
digital input (DVD, TV, CD, CD-R,
VCR or OFF).
After you assign a component to the digital
jack, whenever you select that component,
for example a DVD player, the receiver
automatically changes to the digital input
setting and DIGITAL shows in the display.
Optical Digital Input Setting
Default setting: TV
Here you tell the receiver what component
you have connected to the optical input
jack.
Use  or  to select the optical
digital input (DVD, TV, CD, CD-R,
VCR, or OFF).
31_5021.RCA.33.37 03.3.17, 8:25 PM36

RCA Professional series Specifications

General

Brand	RCA
Model	Professional series
Category	Receiver
Language	English