RCA Professional series User Manual

41
Making a Recording
Making an Audio or a
Video Recording
You can make an audio or a video recording
from the built-in tuner, or from an audio or
video source connected to the receiver (such
as a CD player or TV) through the analog
jacks. You will need to connect a CD
recorder, tape deck, MD, VCR, or DVR deck
to the CD-R TAPE/MD or VCR DVR outputs
on the receiver to do so (see pages 15–17 for
more on this).
Note:
The receiver's volume, balance, tone (bass,
treble, loudness), and surround effects have
no effect on the recorded signal.
1 Select the source you want to
record.
Use the INPUT SELECTOR buttons on
the remote (or MULTI JOG dial on the
front panel).
2 Prepare the source you want to
record.
Tune to the radio station, load the CD,
video, DVD or other media.
3 Prepare the recorder (connected to
either the CD-R TAPE/MD or VCR
DVR
outputs).
Insert a blank tape, MD, video or other
media. into the recording device and set
the recording levels.
Refer to the instructions that came with
the recorder if you are unsure how to do
this. Most video recorders set the audio
recording level automatically—check the
component’s instruction manual if you
are unsure.
4 Start recording, then start
playback of the source component.
Monitoring Your Recording
You can listen to (monitor) the recording as
it is being made using the MONITOR button
on the front panel (a cassette deck would
have to have a record monitor function).
Press the MONITOR button to switch
between the recorded signal and the
original source signal.
31_5021.RCA.38.41 03.3.17, 8:25 PM41

RCA Professional series Specifications

General

Brand	RCA
Model	Professional series
Category	Receiver
Language	English