IF.UG.IM_R1
3.4 Warning for System Preparations
1. Perform a risk assessment for the area in which you plan to use the System, to ensure the
classification of the area does not change.
2. To provide quick access for disconnecting power in case of emergency, do not block access
to the System power switch, receptacles where the power cords are plugged in, or the main
circuit disconnect.
3. To prevent the System from overheating, do not block the air intake or exhaust openings on
the Controller Cabinet.
4. To avoid risk of electric shock, this equipment must only be connected to AC mains with
protective earth using a twist lock connector. No modification of this equipment is allowed.
5. To avoid injuries from tripping, route and secure all piping and tubing sensibly and keep
them out of the user’s way.
6. Before starting up the System, inspect all mechanical and electrical components thoroughly
for potential damages. These include punctured bags and tubing, damaged connections, and
loosen electrical connections.
7. Only use the System in an indoor environment with an ambient atmosphere meeting the
operating specifications.
8. Do not plug in or introduce electricity to the System during Mechanical Assembly.
9. Do not introduce power or plug the System in a power outlet during Electrical Connections
procedure until instructed to do so.
3.5 Warnings for System Operation
To Next Page
Loading...
Need help?
General
