When You Have Problems Operating the
Machine
This section
describes common problems and messages. If other messages appear, follow the instructions
displayed.
Problem Causes Solutions
Although the copier screen
appears when the machine is
turned on using the main
power switch, it cannot be
switched to another screen by
pressing the [Printer] or
[Scanner] key.
Functions other than the
copier function are not yet
ready.
Wait a little longer.
The machine has just been
turned on and the User Tools
screen is displayed, but the
User Tools menu has items
missing.
Functions other than the
copier function are not yet
ready. Time required varies
by function.
Functions appear
in the User Tools menu when
they become ready for use.
Wait a little longer.
The operation switch
indicator continues blinking
and does not turn off when
pressed.
This occurs in the following
cases:
• The machine is
communicating with
external equipment.
•
The hard disk is active.
• Check if the machine is
communicating with external
equipment.
• Wait a little longer.
The display is off. The machine is in Energy
Saver mode.
Press the [Energy Saver] key to cancel
Energy Saver mode.
The display is off. The operation switch is turned
off.
Turn on the operation switch.
Nothing happens when the
operation switch
is turned on.
The main power switch is
turned off.
Turn on the main power switch.
"Please wait." appears. This message appears when
you turn on the operation
switch.
Wait for a while. If the machine does not
get ready in two minute, contact your
service representative.
1. When the Machine Does Not Operate As Wanted
16
To Next Page
Loading...
Need help?
General
