Ricoh MP 402SPF User Manual

Messages Displayed When You Use the Printer
Function
This section describes the principal messages that appear on the display panel, error logs or reports. If
other messages appear, follow their instructions.
Messages Displayed on the Control Panel When You Use the Printer Function
• Before turning off the power, see page 62 "Turning On/Off the Power".
Message Cause Solution
"Hardware Problem:
Ethernet"
An error has occurred in the
Ethernet interface.
Turn off the power, and then back on
again. If the message appears
again, contact your service
representative.
"Hardware Problem: HDD" An error has occurred in the
hard disk.
Turn off the power, and then back on
again. If the message appears
again, contact your service
representative.
"Hardware Problem: USB" An error has occurred in the
USB interface.
Turn off the power, and then back on
again. If the message appears
again, contact your service
representative.
"Hardware Problem:
Wireless Card"
(A "wireless LAN board" is
referred to as a "wireless
card".)
• The wireless LAN board
has malfunctioned.
• The wireless LAN board
you are using is not
compatible with this
machine.
Turn off the power, and then confirm
the wireless LAN board is inserted
correctly. And then, turn on the
power again. If the message
appears again, contact your service
representative.
10. Troubleshooting
178

Ricoh MP 402SPF Specifications

General

Brand	Ricoh
Model	MP 402SPF
Category	All in One Printer
Language	English