2. Install it on the new EGB with the mark [A] pointing to the right side of the board
after you replace the EGB.
3. Replace the EEPROM if the EEPROM on the old EGB is defective.
• Keep the EEPROM away from objects that can cause static electricity. Static electricity can
damage EEPROM data.
• Make sure that the EEPROM is correctly installed on the EGB.
EGB (MF Models)
1. Rear cover (page 32 "Rear Cover")
2. Controller box cover (page 99 "Controller Board")
3. FCU and Speaker bracket (page 99 "Controller Board")
4. Replacement and Adjustment
104
To Next Page
Loading...
Need help?
General
