Error Type Error Description Error Code
Comm. Error Command Rec Error xxxx68
Resp Rec Error xxxx69
Time Out xxxx70
Modem hang-up xxxx80
V34 abort received xxxx81
V34 t1 timeout, control channel error xxxx82
V34 t1 timeout, primary channel error xxxx83
Data not sent until guard timer expired xxxx84
The following information is also included in the User Guide.
Error Code Solution
1XXX11 An original has been jammed inside the ADF while sending a fax in
Immediate Transmission mode.
• Remove jammed originals, and then place them again.
• Check the originals are suitable for scanning.
1XXX21 The line could not be connected correctly.
• Check if the telephone line is properly connected to the machine.
• Disconnect the telephone line cord from the machine, and connect
the cord to a telephone. Check if you can make calls using the
telephone. If you cannot make calls this way, contact your telephone
company.
1XXX22 to 1XXX23 Dial fails when trying to send faxes.
• Check if that the fax number you dialed is correct.
•
Check if that the destination is a fax machine.
• Check if that the line is not busy.
• You may need to insert a pause between dial digits. Press the
[Pause/Redial] key after, for example, the area code.
• Check if [PSTN / PBX] under [Admin. Tools] has been specified
properly for your connection method to the telephone network.
6. Troubleshooting
178
To Next Page
Loading...
Need help?
General
