When Other Messages Appear
The messages related to scan function, destination list, user certificate and LDAP server are displayed on
Type 1, 2 and 3 machines.
Messages Causes Solutions
"Cannot connect with the
wireless card. Turn the main
power switch off, then check the
card."
(A "wireless LAN board" or
"Bluetooth interface unit" is
referred to as a "wireless card".)
• The wireless LAN board
was not inserted when the
machine was turned on.
• The wireless LAN board
was pulled out after the
machine was turned on.
• The settings are not
updated although the unit
is detected.
Turn off the power, and then
confirm the wireless LAN board
is inserted correctly. After
confirmation, turn on the power
again. If the message appears
again, contact your service
representative.
"Cannot connect with the
Bluetooth interface. Check the
Bluetooth interface."
• The Bluetooth interface unit
was installed while the
machine was turned on.
• The Bluetooth interface unit
was removed while the
machine was turned on.
Turn off the power, and then
confirm that the Bluetooth
interface unit was installed
correctly. After confirmation,
turn on the power again. If the
message appears again,
contact your service
representative.
"Clean the scanning glass.
(Located next to the exposure
glass.)"
The scanning glass or guide
plate of the ADF is dirty.
Clean them. See "Maintaining
Your Machine", Maintenance
and Specifications .
9. Troubleshooting
216
To Next Page
Loading...
Need help?
General
