Preparing for Printing
20
1
H Specify the location where the source files of the printer driver are stored.
If the CD-ROM drive is D, the source files of the PostScript 3 printer driver
are stored in the following location:
D:\DRIVERS\PS\XP_VISTA\(Language)\DISK1
I Check the printer driver location, and then click [OK].
J Click [Next >].
K Click [Finish].
If the printer driver has already been installed, plug and play is enabled, and
the icon of the printer connected to the “USB001” port is added to the [Printers]
window.
Note
❒ To disable Auto Run, press the {Shift} key when inserting the CD-ROM
into the drive and keep it pressed until the computer finishes reading from
the CD-ROM.
❒ The number after “USB” varies depending on the number of printers con-
nected.
❒ The USB port is available only for the printer driver that is installed first.
To install additional drivers for this printer, install them using other ports
(such as LPT1). Then, after the installation, change the port settings to the
specified USB port.
Installing the PostScript 3 Printer Driver (Windows Vista and
Windows Server 2008)
Important
❒ To install this printer driver, you must have an account that has Manage
Printers permission. Log on as an Administrators group member.
If the printer driver is already installed and plug and play is enabled, the icon of
the printer connected to the “usb” port appears in the [Printers] window.
The printer drivers can be installed from the CD-ROM provided with this printer.
If the printer driver is not already installed, follow the printer's plug-and-play
instructions to install it from the provided CD-ROM.
A Connect the printer and computer using the USB cable.
Connect the USB cable firmly.
The [Found New Hardware] dialog box appears.
B Click [Locate and install driver software (Recommended)].
If the [User Account Control] dialog box appears, click [Continue].
To Next Page
Loading...
Need help?
General