Riello CONDEXA HPR Series User Manual

GENERAL REMARKS
8
(*) Average value of various hot water operating conditions
(**) Check made with concentric pipe Ø 60-100 (CONDEXA HPR 35-45) - Ø 80-125 (CONDEXA HPR 55-70), length 0.85 m - in heating, water
temperature 80-60°C - values measured with the casing completely closed
The data indicated must not be used to certify the system; for certication, use the data indicated in the “System handbook” meas-
ured during rst ignition.
NOTE
With reference to the Delegated Regulation (EU) No. 811/2013, the information in the table can be used for completing the product data
sheet and the labelling for room heating appliances, for mixed heating appliances, for all those appliances for enclosed space heating,
for temperature control devices and solar devices:
COMPONENT CLASS BONUS
OUTDOOR TEMPERATURE SENSOR II 2%
REMOTE CONTROL OT+ V 3%
OUTDOOR TEMPERATURE SENSOR + REMOTE CONTROL OT+ VI 4%
DESCRIPTION UM
CONDEXA HPR
35 45 55 70
Gas pressure G20 G31 G20 G31 G20 G31 G20 G31
Nominal natural gas pressure (G20 - I2H) mbar 20 - 20 - 20 - 20 -
Nominal liquid gas pressure - LPG (G31 - I3P) mbar - 37 - 37 - 37 - 37
Heating input - output Ø 1” 1/2 M 1” 1/2 M 1” 1/2 M 1” 1/2 M
Gas input Ø 3/4” 3/4” 3/4” 3/4”
Storage tank inlet - outlet Ø 1” 1/2 M 1” 1/2 M 1” 1/2 M 1” 1/2 M
Heating output G20 G31 G20 G31 G20 G31 G20 G31
Air ow rate Nm
3
/h 42,399 43,309 54,670 55,843 66,819 68,252 85,042 86,866
Flue gas ow rate Nm
3
/h 45,900 46,016 59,184 59,333 72,336 72,518 92,064 92,295
Mass ue gas ow rate (max-min) g/s
15,855-
2,362
16,223-
2,417
20,443-
2,362
20,918-
2,417
24,986-
3,725
25,567-
3,812
31,800-
3,725
32,540-
3,812
DHW ow rate G20 G31 G20 G31 G20 G31 G20 G31
Air ow rate Nm
3
/h 42,399 43,309 54,670 55,843 66,819 68,252 85,042 86,866
Flue gas ow rate Nm
3
/h 45,900 46,016 59,184 59,333 72,336 72,518 92,064 92,295
Mass ue gas ow rate
(max-min)
g/s
15,855-
2,362
16,223-
2,417
20,443-
2,362
20,918-
2,417
24,986-
3,725
25,567-
3,812
31,800-
3,725
32,540-
3,812
Fan performance
Residual discharge head of concentric pipes
0.85 m
Pa 60 60 - -
Residual discharge head of separate pipes 0.5 m Pa 160 192 172 197
Residual discharge head of boiler without pipes Pa 166 198 180 200
Concentric ue gas exhaust pipes
Diameter mm 60-100 60-100 60-100 60-100
Maximum length m 10 10 - -
Loss for insertion of a 45°/90° bend m 1,3/1,6 1,3/1,6 1,3/1,6 1,3/1,6
Hole in wall (diameter) mm 105 105 105 105
Diameter mm 80-125 80-125 80-125 80-125
Maximum length m 25 25 10 10
Loss for insertion of a 45°/90° bend m 1/1,5 1/1,5 1/1,5 1/1,5
Hole in wall (diameter) mm 130 130 130 130
Separate ue gas exhaust pipes
Diameter mm 80 80 80 80
Maximum length m 30+30 21+21 12+12 10+10
Loss for insertion of a 45°/90° bend m 1/1,5 1/1,5 1/1,5 1/1,5
Forced open installation B23P-B53P
Diameter mm 80 80 80 80
Maximum discharge tube length m 48 33 17 13
NOx class 6 6 6 6
Emission values at maximum and minimum output (**) G20 G31 G20 G31 G20 G31 G20 G31
Maximum CO s.a. lower than p.p.m. 120 130 150 160 170 170 220 230
CO2 % 9,0 10,0 9,0 10,0 9,0 10,0 9,0 10,0
NOx s.a. lower than p.p.m. 50 50 60 60 50 50 60 60
Flue gas temperature °C 68 66 71 73 66 70 70 76
Minimum CO s.a. lower than p.p.m. 30 30 30 30 40 20 40 20
CO2 % 9,0 10,0 9,0 10,0 9,0 10,0 9,0 10,0
NOx s.a. lower than p.p.m. 40 45 40 45 40 60 40 60
Flue gas temperature °C 60 58 60 58 57 58 57 58

Riello CONDEXA HPR Series Specifications

General

Brand	Riello
Model	CONDEXA HPR Series
Category	Water Heater
Language	English