68 Rockwell Automation Publication 2080-UM002N-EN-E - November 2022
Chapter 5 Communication Connections
Ethernet Host Name
Micro800 controllers implement unique host names for each controller, to be used to identify
the controller on the network. The default host name is comprised of two parts: product type
and MAC address, separated by a hyphen. For example: 2080-LC50-xxxxxxxxxxxx, where
xxxxxxxxxxxx is the MAC address.
The user can change the host name using the CIP Service Set Attribute Single when the
controller is in Program/Remote Program mode.
Configure CIP Serial Driver 1. Open your Connected Components Workbench project. On the device configuration tree,
go to the Controller properties. Click Serial Port.
2. Select CIP Serial from the Driver field.
3. Specify a baud rate. Select a communication rate that all devices in your system
support. Configure all devices in the system for the same communication rate. Default
baud rate is set @ 38,400 bps.
4. In most cases, parity and station address should be left at default settings.
5. Click Advanced Settings and set Advanced parameters.
OPC Support Using
FactoryTalk Linx
Support for Open Platform Communications (OPC) using CIP symbolic has been added from
firmware release 7.011 onwards. This can be used in place of Modbus addressing.
FactoryTalk® Linx software version 5.70 (CPR9 SR7) or later and FactoryTalk® Linx Gateway
software version 3.70 (CPR9 SR7) or later are required.
To Next Page
Loading...
Need help?
General
