132 Publication 2711P-UM001I-EN-P - December 2008
Chapter 5 Windows CE .NET Operating System
Extended Diagnostics
From the Extended Diagnostics dialog, you can:
• enable/disable extended diagnostics to run on the PanelView
Plus CE terminal at each reset or power cycle.
• select specific tests to run.
• specify the number of times to repeat each test.
When done performing operations, remember to select OK in the title
bar to activate settings.
Iteration Count
From the Iteration tab, check the Enable Extended Diagnostic
checkbox to run selected tests on the PanelView Plus CE terminal at
each reset or startup. You can also specify how many times to run
each test. The tests are selected from the Tests and More Tests tab.
The selected tests will run each time the PanelView Plus CE terminal is
reset until disabled (by unchecking the Enable Extended Diagnostics
checkbox).
TIP
Enabling Extended Diagnostics and setting a high Iteration
count will increase the time it takes for the terminal to start up.
The tests will run each time you reset or cycle power to the
terminal until you disable Extended Diagnostics. Setting a low
iteration count will also decrease the start up time.
To Next Page
Loading...
Need help?
General
