162 Publication 2711P-UM001I-EN-P - December 2008
Chapter 6 Install and Replace Components
Remove the Product ID
Label
You can remove the label on your terminal and attach your own label.
1. Remove the Allen-Bradley label using your fingers or a tweezers.
2. Clean area with damp cloth and isopropyl alcohol.
3. Remove adhesive backing of OEM label and affix over area
where label was located.
Replace the Keypad Legend
Inserts
This section shows how to replace the legend inserts in the keypad
terminals. The legend strips are available as separate catalog numbers
for each keypad terminal, except for the PanelView Plus 400 terminal,
which does not support replaceable legend strips. One side of the
legend strips have the default key legends and the other side is blank
for creating custom legends.
PanelView Plus 600 Terminal
The legend inserts for function keys F1 through F10 are accessible
from the back on the unit and can be replaced with the terminal
mounted in the enclosure.
Follow these steps to replace the F1 through F10 function key
legends.
1. From the rear of the unit, pull the legend strips out from the
slots on the lower side of the terminal.
2. Slide the new insert into the same slot until only the end tab is
visible.
To Next Page
Loading...
Need help?
General
