Publication 2711P-UM001I-EN-P - December 2008 187
Terminal Connections Chapter 7
NAP and Redundant Cables
Refer to the ControlNet Coax Media Planning and Installation Guide,
publication CNET-IN002, for descriptions of ControlNet components.
Connect the Module to the Network
You can connect the ControlNet Module:
• directly to a ControlNet network, which requires a tap.
• to a device already connected to the ControlNet network.
DeviceNet Module
Terminals with a DeviceNet communication module support
communication and the transfer of applications between devices on a
DeviceNet network.
Item Cat. No.
RG-6 quad-shield 1786-RG6
Coax repeater 1786-RPT, -RPTD
Coax taps 1786-TPR, -TPS, -TPYR, -TPYS
Network access cable 1786-CP
Coax tool kit 1786-CTK
Segment terminators 1786-XT
BNC connectors 1786-BNC, -BNCJ, -BNCP, -BNCJ1
IMPORTANT
Do not connect to a network using both the redundant cable
BNC connector and the Network Access Port (NAP).
WARNING
When used in a Class I, Division 2, hazardous location, this
equipment must be mounted in a suitable enclosure with
proper wiring that complies with the governing electrical
codes.
Do not connect or disconnect any communication cable with
power applied to this device or any device on the network. An
electrical arc could cause an explosion in hazardous location
installations. Be sure that power is removed or the area is
nonhazardous before proceeding.
To Next Page
Loading...
Need help?
General
