136
Adding Effects
Chorus
fig.22-022
Chorus Type
Selects either chorus or delay.
Value
0 (Off):
Neither chorus or delay is used.
1 (Chorus):
Chorus is used.
2 (Delay):
Delay is used.
3 (GM2 Chorus):
General MIDI 2 chorus
Chorus Output
fig.22-022a
Chorus Output Level
Adjusts the volume of the sound that has passed through
chorus.
Value:
0–127
Chorus Output Select
Specifies how the sound routed through chorus will be output.
Value
MAIN:
Output to the OUTPUT jacks in stereo.
REV:
Output to reverb in mono.
M+R:
Output to the OUTPUT jacks in stereo, and to reverb
in mono.
When set to “MAIN” or “M+R,” the OUTPUT jack from which
the sound is output is set in Chorus Output Assign ( ).
Chorus Output Assign
Selects the pair of OUTPUT jacks to which the chorus sound is
routed when Chorus Output Select ( ) is set to “MAIN” or
“M+R.”
Value
A:
Output to the OUTPUT A (MIX) jacks in stereo.
B:
Output to the OUTPUT B jacks in stereo.
When Chorus Output Select ( ) is set to “REV,” this setting
will have no effect.
If the Mix/Parallel parameter is set to “MIX,” all sounds are
output from the OUTPUT A (MIX) jacks in stereo (p. 158).
Reverb
fig.22-023
Reverb Type
Selects the type of reverb.
Value
0 (Off):
Reverb is not used.
1 (Reverb):
Normal reverb
2 (SRV Room):
This reverb simulates typical room acoustic
reflections.
3 (SRV Hall):
This reverb simulates typical concert hall
acoustic reflections.
4 (SRV Plate):
This reverb simulates a reverb plate, a
popular type of artificial reverb unit that
derives its sound from the vibration of a
metallic plate. You can also achieve unusual
metallic-sounding reverbs using “SRV
Plate.”
5 (GM2 Reverb):
General MIDI 2 reverb
11
12
13
14
14
13
13
15
Fantom-XR_r_e.book 136 ページ ２００６年４月４日 火曜日 午前１０時１４分
To Next Page
Loading...
Need help?
General
