156
Settings Common to All Modes (System Function)
This section explains what the different System parameters do, and also how these parameters are organized.
For details on these settings, refer to
“How to Make System Function Settings”
(p. 155).
Functions of System Parameters
System Startup
Parameter
Value Description
LCD Contrast
1–20 This adjusts the contrast/brightness of the display. Higher values will make
the characters darker.
Startup w/PresetSamp
(Load Preset Samples at Startup)
OFF, ON Specifies whether the preset samples will be loaded into memory at power-on
(ON) or not (OFF).
Startup w/User Samp
(Load User Samples at Startup)
OFF, ON Specifies whether the samples of the user area and memory card will be load-
ed into memory at power-on (ON) or not (OFF).
Power Up Mode
PATCH, PERFORM This setting allows you to choose the mode that you want the Fantom-XR to
be in when it is powered up.
PATCH:
The Fantom-XR will be in Patch mode when you turn on
the power.
PERFORM:
The Fantom-XR will be in Performance mode when you
turn on the power.
System Sync/Tempo
Parameter
Value Description
Sync Mode
MASTER, SLAVE
Specifies the synchronization message that the Fantom-XR will use for oper-
ation.
MASTER:
The Fantom-XR will be the master. Choose this setting when
using the Fantom-XR by itself without synchronizing to
another device.
SLAVE:
The Fantom-XR will be the slave. Choose this setting when
you want the Fantom-XR to synchronize to MIDI Clock
messages received from another MIDI device.
Tempo (System Tempo)
5–300
Sets the system tempo.
* When Sync Mode is set to “SLAVE,” the tempo will synchronize to the clock
messages received from an external MIDI device, so the tempo value will be
ignored.
* The tempo value is not saved even if you save the System settings.
Tempo Override
OFF, ON
Specify whether the system tempo will change (ON), or will not change (OFF)
when you switch performance.
System MIDI
Parameter
Value Description
Device ID (Device ID Number)
17–32
When you want to transmit or receive System Exclusive messages, set this
parameter to match the Device ID number of the other MIDI device.
Performance Ctrl Ch
(Performance Control Channel)
1–16, OFF
Performance Ctrl Ch selects the MIDI receive channel used during switching of
performances when MIDI messages (Program Change/Bank Select) are sent
from an external MIDI device. Set this to “OFF” if performances are not to be
switched from an external MIDI device.
If only a program change is received, and if the Performance Ctrl Ch
parameter setting coincides with the MIDI receive channel of a part,
priority will be given to switching the performance.
Patch Mode Rx Ch
(Patch Mode Receive Channel)
1–16
Specifies the channel used to receive MIDI messages in Patch mode.
Fantom-XR_r_e.book 156 ページ ２００６年４月４日 火曜日 午前１０時１４分
To Next Page
Loading...
Need help?
General
