Getting Ready
10
NOTE
• You must use the included screws.
• You must use the included Allen wrench to tighten or remove
the screws. Using a tool that does not match the screw heads
will damage them.
• Be careful not to over-tighten the screws. Doing so may damage
the screw’s head, causing the wrench to rotate uselessly.
• To tighten the screws, turn the Allen wrench clockwise. To
loosen the screws, turn the Allen wrench counter-clockwise.
loosen tighten
• Keep the removed screws out of the reach of small children to
ensure they are not swallowed accidentally.
• Never allow foreign objects (e.g., coins, wires) to enter the USB
memory box.
Placing the VR-09 on a Stand
Be careful not to pinch your ngers when setting up the stand.
If you place the VR-09 on a stand, you must use the KS-18Z or the KS-12.
Place the instrument on the stand as follows.
* If using a pedalboard (PK-9; sold separately), please use the KS-12.
KS-18Z
Align the front of the
VR-09 with the front
of the stand
Adjust so that
the height does
not exceed 1
meter (Adjust
the stand to a
level no higher
than the fth
level from the
bottom)
Adjust the width of the stand so
that the rubber feet of the VR-09
straddle the stand
Top view
KS-12
Adjust the width of the stand
so that the rubber feet on the
keyboard side of the bottom of
the keyboard t into the holes
provided for the rubber feet.
Top view
Using the Included USB Memory Protector
You can use the included USB memory protector to prevent theft of the USB ash drive connected to the VR-09.
To Next Page
Need help?
General
Weight and Dimensions
